EV chargers & equipment
EV chargers, hot tubs, heat pumps, shop tools. The wire is the easy part. The real job is making sure your panel can carry the load, and fixing it if it can’t.
EV charger installation
A Level 2 charger draws as much as a whole extra kitchen. Before we run a wire, we check what your panel can actually carry with everything else that’s already on it. If there’s room, we install a dedicated circuit to your charger, mounted where you want it, run cleanly. If there isn’t, we’ll tell you straight and quote the service upgrade that makes room for it.
Hardwired or on a receptacle, your choice. We run the circuit to where the car actually parks, and we install customer-supplied chargers or source one for you. Either way you get a clean, code-compliant install with the permit and inspection handled.
Other equipment we wire
- Hot tubs: GFCI-protected, correctly bonded, with the disconnect where code requires it.
- Heat pumps & mini-splits: the circuit and disconnect for your HVAC installer, sized right.
- Ranges & ovens: including the switch from gas to induction.
- Shop & garage: sub-panels, 240V tool circuits, lighting, welder plugs.
Why the panel check matters
The most common mistake with equipment installs is adding load a panel can’t safely carry. It might work for a while, then start tripping, or worse. We do a load calculation up front so what we install is safe on day one and stays that way.
How we quote it
Most equipment installs come down to the distance from your panel and whether the panel has room. We can’t price one sight-unseen, but a photo of your panel and where the equipment is going tells us most of what we need before we come out.
Ready to get started?
Send a photo of your panel and where you want the charger, and we’ll come prepared.